Difficulty
Moderate
Steps
5
Time Required
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
User-Contributed Guide
This guide is not managed by the site's staff.
-
-
The latest version of the hydraulic diagram is shown at left. The paged linked to from the dev board linked to on dozuki is the primary source for this.
-
-
-
Lay each cable and all the adapters for the cables out on the floor of the workshop, along a line, in the order to which they are to be assembled, according to the diagram.
-
There are 6 hoses in the diagram, but you probably already have 2 assembled, as they will be running from the powercube to the lifetrac cabin.
-
-
-
take some teflon tape to seal the tapered threads with.
-
Remember to wrap the tape only clockwise, such that the end of the tape is dragged along, rather than push along, during the rotation that occurs during tightening, to prevent bunching up of the tape.
-
Assemble the parts, starting from one end and moving towards another. With each part, check to make sure the threads are free of dirt, wiping them with a rag if you need to.
-
Cancel: I did not complete this guide.
One other person completed this guide.
