Changes to Step #2
Edit by Andrew Graham —
Edit approved by Marcin
- Before
- After
- Unchanged
Step Lines
| + | [* 1] Tack sidewall P4 into place at 90 degrees. |
|---|---|
| + | [* 1] Hold sidewall (P5) into place, and then stick Shaft 21 through the bearings to ensure proper alignment of side walls. Tack sidewall (P4). Now tighten the bolts, ensuring the shaft is aligned correctly. |
| + | [* 1] Finish welding the seams for the back plate, bottom sheet and sidewalls (P1, P3, P4, P5). Weld in the 1" nuts on the inside side of the sidewalls |
Image 1
No previous image
Added
Image 2
No previous image
Added