You're viewing a previously published revision of this guide. View latest revision

Mar 31, 2014 - 12:03:28

Apr 01, 2014 - 08:04:08 Mar 31, 2014 - 05:03:06 Mar 31, 2014 - 12:03:13 Mar 31, 2014 - 12:03:10 Mar 31, 2014 - 12:03:07 Mar 31, 2014 - 12:03:26 Mar 31, 2014 - 12:03:18 Mar 31, 2014 - 12:03:09 Mar 31, 2014 - 12:03:28 Mar 31, 2014 - 12:03:26 Mar 31, 2014 - 12:03:34 Mar 31, 2014 - 12:03:34 Mar 31, 2014 - 12:03:05 Mar 31, 2014 - 12:03:05 Mar 31, 2014 - 12:03:16 Mar 31, 2014 - 12:03:16 Mar 31, 2014 - 12:03:59

Newer

Installing Module - Drive Hydraulic Motor and Drive

Written By: Andrew Graham (and one other contributor)

Comments: 0
Favorites: 0
Completions: 1

Installing Module - Drive Hydraulic Motor and Drive

Difficulty

Moderate

Steps

Time Required

Suggest a time??

Step 1 Hydraulic Motor and Drive

Attach the coupler on the motor to the drive shaft with the 1/2" x 4"bolt.

Fit the motor and coupler to the main rotor shaft, P21

Attach the coupler on the motor to the drive shaft with the 1/2" x 4"bolt.
Fit the motor and coupler to the main rotor shaft, P21

Step 2

Pass the 12" long, 1" threaded rods through p24 then through the tubes (not shown), through p23 and thread them through the nuts welded to the far side of P4.

Attach the 4 further nuts to clamp the motor to the tubes, and the tubes against p23, in a sandwich

Pass the 12" long, 1" threaded rods through p24 then through the tubes (not shown), through p23 and thread them through the nuts welded to the far side of P4.
Attach the 4 further nuts to clamp the motor to the tubes, and the tubes against p23, in a sandwich

Step 3

Ensure the system rotates freely 360 degrees. If the coupler, motor and shaft are not on the same axis, it may lock up.
Check that when torque is applied to the motor, in either direction, there is no excessive twisting.