Installing Module - Drive Hydraulic Motor and Drive

Written By: Andrew Graham (and one other contributor)
  • Comments: 0
  • Favorites: 0
  • Completions: 1

Difficulty

Moderate

Steps

3

Time Required

Suggest a time??

Sections

1

Flags

1

In Progress

In Progress

This guide is currently being written. Reload periodically to see the latest changes.

  1. Attach the coupler on the motor to the drive shaft with the 1/2" x 4"bolt. Fit the motor and coupler to the main rotor shaft, P21

    • Attach the coupler on the motor to the drive shaft with the 1/2" x 4"bolt.

    • Fit the motor and coupler to the main rotor shaft, P21

    Edit

  2. Pass the 12" long, 1" threaded rods through p24 then through the tubes ], through p23 and thread them through the nuts welded to the far side of P4. Attach the 4 further nuts to clamp the motor to the tubes, and the tubes against p23, in a sandwich Tighten the 2 screws in the collars of both bearings to the shaft (should be separated by 120 degrees).

    • Pass the 12" long, 1" threaded rods through p24 then through the tubes ], through p23 and thread them through the nuts welded to the far side of P4.

    • Attach the 4 further nuts to clamp the motor to the tubes, and the tubes against p23, in a sandwich

    • Tighten the 2 screws in the collars of both bearings to the shaft (should be separated by 120 degrees).

    Edit

    • Quality Control Checklist

    • Ensure the system rotates freely 360 degrees. If the coupler, motor and shaft are not on the same axis, it may lock up.

    • Check that when torque is applied to the motor, in either direction, there is no excessive twisting.

    Edit
Finish Line

One other person completed this guide.

Author

with 1 other contributor

Andrew Graham

Member since: 02/15/2014

197 Reputation

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 123