Difficulty
Moderate
Steps
19
Time Required
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
Quiz
0
-
-
Attach bearing to "middle plate" (insert part number) as shown in image.
-
Be mindful of orientation of grease zerk relative to plate. Must remain accessible once unit is fully assembled.
-
-
-
Attach bearing to "large bearing plate" (insert part number). This bearing faces inside the mount - towards the other bearing.
-
-
-
Attach motor to plate. (insert part number)
-
-
-
Place hub. Insert nut and pin to hold in place.
-
-
-
Info about the hub to plate or something
-
Should this be earlier?
-
-
-
Place hub-to-chain-link coupler.
-
Tighten nuts in a star pattern.
-
-
-
Cut 3" shaft with bandsaw
-
Mill hole
-
-
-
Mill slot in shaft
-
-
-
Step 9
-
-
-
Step 10
-
-
-
Step 11
-
-
-
Insert wisdom here.
-
-
-
Insert wisdom here.
-
-
-
Insert wisdom here.
-
-
-
Insert wisdom here.
-
-
-
Insert wisdom here.
-
-
-
With the rotor and double chin coupler assembly put on the two bearings but place the key and the shaft first to join the shaft and the mowith the rotor and double chin coupler assembly put on the two bearings but place the key and the shaft first to join the shaft and the motor assembly.
-
-
-
Use the clamp to hold the key in place as a rubber mallet is used to punch the shaft
-
-
-
Loosen the setscrew on the collar to allow the key to go in. It's a three-quarter inch key.
-
