CEB Leg Holders

Written By: Dozuki System
  • Comments: 0
  • Favorites: 0
  • Completions: 1

Difficulty

Moderate

Steps

2

Time Required

00:30:00

Sections

1

Flags

1

User-Contributed Guide

User-Contributed Guide

This guide is not managed by the site's staff.

Introduction

We suggest you prepare all leg holders at once, doing each step for all leg holders before moving on.

  1. You will need 14 Leg Holders for the CEB. 12 will be used in this step. Save the remaining ones for later. Make all leg holders at once to save time. Torch a 3/4” hole in the center of one of the faces of the tubing; make sure it's large enough for a 3/4” bolt.

    • You will need 14 Leg Holders for the CEB. 12 will be used in this step. Save the remaining ones for later. Make all leg holders at once to save time.

    • Torch a 3/4” hole in the center of one of the faces of the tubing; make sure it's large enough for a 3/4” bolt.

    • It's not crucial that the hole be centered. It just needs to be somewhere close to the center.

    Edit

  2. Weld the nut over the hole, ensuring the nut is level, and the hole is clear. Make sure no spatter goes into the threads by covering the top of the nut.

    • Weld the nut over the hole, ensuring the nut is level, and the hole is clear.

    • Make sure no spatter goes into the threads by covering the top of the nut.

    • Thread the bolt onto the nut.

    Edit
Finish Line

One other person completed this guide.

Author

Dozuki System

Member since: 09/24/2009

1 Reputation

34 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 2

All Time: 577