1
2
3
4
5
6
7
8
9
Clamp the drawer member centered, 7" from the upper cross member.
The drawer slots should be on this side, not opposite.
Make sure the adjustment nuts are facing where the drawer was, look at the picture.
Clamp the wide cylinder support adjacent to it.
Make sure you label each component for re-assembly later.
Mag-Drill 1" holes at these centers.
Don't bolt these yet, you'll do that later.
« Previous
Next »
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help