1
2
3
4
5
6
7
8
Weld the two together on the top. There will need to be at least 2 layers of weld.
Warning: Dunk this frequently, even if the shaft is not getting hot! The plate will warp upwards and cause you lots of woe if you do not.
Weld the press foot support pieces as close as you can to the tubing and the press plate.
« Previous
Next »
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help