Loosely bolt the assembled motor to the mount, as shown, using washers on both sides, and a lock washer touching the nut.
Put the bearings onto the shaft, ensuring that the eccentric side is facing inwards.
Remember to put the eccentrics in between the two bearings.
The eccentrics are little collars with lopsided circles inside of them. This makes it so they can lock into the bearings.
Ensure that both collars are facing the right direction (so they will lock onto the lip) and that the bearings are also.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.