Install the hopper supports into the leg holders.
Make sure you put the support with bolts on it on the correct side (refer to your shaker motor and look where you marked it.)
Their bottom side should be flush with the bottom of the leg holders on the frame.
Make sure they are orientated correctly. See photo.
On the side of the shaker motor that you didn't weld bolts for, put a bolt (3/4"x1.5") thru both holes and tighten nuts onto them.
The nut should be on the side of the mount that the motor will be installed to. (see photo)
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.