SQUARE FRAME, SET SPACING AND TORQUE BOLTS (continued)

Using fixtures, set the location of the Name plate, Z motor mounts and Feed tube holder.

Tighten all the bolts at this point.

Is the frame square?

Are all the gaps at the ends of the extrusion closed?

Are the edges of the parts flush with the extrusion?

Are all the bolts tight? Are there 2x M5 T-nuts in the top front extrusion and 2x M5 T-nuts in the left front extrusion?

Photo 1 - Set Name plate spacing and tighten bolts -- Photo 2 - Z Motor Mount height -- Photo 3 Location of Feed tube holder