Changes to Step #7
Edit by Chris Reinhart —
Edit approved by Chris Reinhart
- Before
- After
- Unchanged
Step Lines
| [* black] The image shows the cut list for the foundation module. You can also link to it and print it out [https://docs.google.com/a/opensourceecology.org/spreadsheet/ccc?key=0ArNBTd6xfT7MdGhhRVdVeVR0UHp3c25pZThqOTVUcWc#gid=0|here] | |
| [* black] Cut the 2x10 boards to the lengths shown in Image 1 or on the cut list in the link above. | |
| - | [* black] Also cut 12 pieces of all-thread to 18" in length. These will be positioned through the forms as shown in Image 2. |
| + | [* black] Also cut 12 pieces of all-thread to 18" in length. These will be positioned through the forms as shown in Image 2. The all-thread will go at the 1/3 points on each side of the module. This means at the 4' and 8' points along each wall, you will drill 5/8" holes halfway up the height of your form boards to feed the all-thread through. |
| [* black] Make 14 wooden stakes about 20" long - this is a great way to put your scrap end cuts from other projects to good use! You can also use metal stakes that are specifically made for retaining concrete forms. | |
| [* black] ***NOTE! If your overlap of the outside form board on the foundation module you are connecting to is not exactly 3 1/2", then the 6' 5" board will not come out to the right length.*** |