Changes to Step #3
Edit by Dozuki System —
Edit approved by Dozuki System
- Before
- After
- Unchanged
Step Lines
| + | [title] Punch the Holes |
|---|---|
| + | [* black] Determine which one is arm A and which is arm B by looking at the diagrams. Label them. |
| + | [* black] On arm A, punch the following holes on the 6” side of the angle iron, measured from the left, each centered 1 3/4” from the long edge: Also, torch the hole for adjusting the rollers at 45". Its shape is shown in the diagrams. |
| + | [* black] Five total 13/16” diameter holes at 9”, 13”, 18”, 28”, and 30" inches. |
| + | [* black] Torch the roller adjustor hole in arm B, 45" from the right, so the holes will be at the same frame location. |
Image 1
No previous image
Added