How to assemble the shear table of the Ironworker (in progress) Step #3 History

Changes to Step #3

Edit by Dan Benamy — Sun 27 Oct 2013 11:48:52 PM MST

Edit approved by Dan Benamy

-	[* black] Put a 6 hole tube which will be the working clamp onto the upright bolts. Put washers and nuts on the bits of bolts sticking through this tube.
+	[* black] Parts:
+	[* black] 1 6 hole, 0.25" tube
+	[* black] 2 1" washers
+	[* black] 2 1" nuts
+	[* black] Put the tube onto the upright bolts. Put washers and nuts on the bits of bolts sticking through this tube. This'll be the working clamp
	[* black] The springs should push the tube up against the top nuts but you should be able to push the tube down an inch or so.