Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #5

Edit by Dan Benamy

Edit approved by Dan Benamy

Before
After
Unchanged

Step Lines

[* black] Parts:
[* black] 1 6 hole, 0.25" tube
- [* black] 2 1" x 16" threaded rod
- [* black] 6 1" washers
- [* black] 2 1" nuts
-[* black] Screw a nut onto one end of each threaded rod and add the washer.
-[* black] Put each threaded rod through a washer, the end holes of the 6 hole tube, and the 2 1 hole tubes.
+ [* black] 4 1" washers
+[* black] Put each threaded rod through the end holes of the 6 hole tube and the 2 1 hole tubes.
[* black] Put 2 washers on each bolt after everything else. The washers will give the table clamp room to move up and down without rubbing against the frame.