Changes to Step #5
Edit by Dan Benamy —
Edit approved by Dan Benamy
- Before
- After
- Unchanged
Step Lines
| [* black] Parts: | |
| [* black] 1 6 hole, 0.25" tube | |
| - | [* black] 2 1" x |
| + | [* black] 2 1" x 16" threaded rod |
| [* black] 6 1" washers | |
| [* black] 2 1" nuts | |
| + | [* black] Screw a nut onto one end of each threaded rod and add the washer. |
| [* black] Put each threaded rod through a washer, the end holes of the 6 hole tube, and the 2 1 hole tubes. | |
| [* black] Put 2 washers on each bolt after everything else. The washers will give the table clamp room to move up and down without rubbing against the frame. |