How to assemble the shear table of the Ironworker (in progress) Step #5 History

Changes to Step #5

Edit by Dan Benamy — Sun 27 Oct 2013 11:35:20 PM MST

Edit approved by Dan Benamy

-	[* black] Put 2 TODO"x1" threaded rod through washers and through the holes on either side of the lower blade plate, from the side with the upper blade.
-	[* black] Put washers over those bolts on both sides.
-	[* black] Put a nut on the end of the bolt sticking out of the side of the ironworker with the top blade.
-	[* black] TODO move/merge to assembly pieces guide: Put 2 TODO"x1" bolts through washers and through the holes on either side of the lower blade plate, from the side with the upper blade.
+	[* black] Parts:
+	[* black] 1 6 hole, 0.25" tube
+	[* black] 2 1" x TODO" threaded rod
+	[* black] 6 1" washers
+	[* black] 2 1" nuts
+	[* black] Put each threaded rod through a washer, the end holes of the 6 hole tube, and the 2 1 hole tubes.
+	[* black] Put 2 washers on each bolt after everything else. The washers will give the table clamp room to move up and down without rubbing against the frame.