Changes to Step #1
Edit by Dan Benamy —
Edit approved by Dan Benamy
- Before
- After
- Unchanged
Step Lines
| [* black] Parts: | |
| [* black] 2 1 hole 0.5" tube | |
| - | [* black] 6 1" nuts |
| - | [* black] 4 1" washers |
| - | [* black] 2 1" springs |
| [* black] 2 1" x TODO" threaded rob (to support clamp) | |
| - | [* black] Put each threaded rod through one side of a 1 hole tube. Bolt it on the inside of the 1 hole cube so that there's room for another bolt to go through the other holes. |
| + | [* black] 4 1" nuts |
| + | [* black] Put a nut near the end of each threaded rod. |
| + | [* black] Stick the little bit after the nut through one side of a 1 hole tube. |
| + | [* black] Bolt it on the inside of the 1 hole cube so that there's room for another bolt to go through the other holes. |
| [* black] Repeat a second time. |
Image 1
Deleted