Changes to Step #2
Edit by Dan Benamy —
Edit approved by Dan Benamy
- Before
- After
- Unchanged
Step Lines
| [* black] Parts: | |
| - | [* black] 2 2 hole x 4 hole plates |
| - | [* black] 6 7" x 1" bolts |
| - | [* black] put the bolts through the plates and then through the frame tubes so that the last two holes on the plate.. |
| - | [* black] 0 photos, timestamp, 7:22, 7:23 |
| + | [* black] 4 2 hole x 4 hole plates |
| + | [* black] 6 1" x 8" bolts |
| + | [* black] 6 1" nuts |
| + | [* black] Put the bolts through 2 plates, through the frame tubes, through the other 2 plates, and loosely put on nuts. |
| + | [* black] The last two holes of the plates should extend past the end of the tubes. |
| + | [* black] The pictures show a 7th nut welded on. You'll install that later so don't worry about it just yet. |
Image 2
No previous image
Added