Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #4

Edit by Dan Benamy

Edit approved by Dan Benamy

Before
After
Unchanged

Step Lines

[* black] Parts:
- [* black] 4 pivot plates (TODO link to guide on how to make them)
+ [* black] 4 pivot plates (TODO link to guide on making them) (for the ironworker, it's very important that the plates be perfectly flat against each other. If there are any bumps, grind them down.)
[* black] 0.5 ounces of grease (Dan made this up, Marcin should verify)
[* black] Put two pivot plates on each side of the frame tubes over the 4 threaded rods.
[* black] Grease the inside of the bushing (round area) on the pivot plates.