Changes to Step #3
Edit by Dan Benamy —
Edit approved by Dan Benamy
- Before
- After
- Unchanged
Step Lines
| [* black] Parts: | |
| [* black] 4 2 hole x 4 hole plates | |
| - | [* black] 6 |
| + | [* black] 6 8" x 1" bolts |
| [* black] 6 1" nuts | |
| [* black] Slide the bolts through two of the plates, the frame tubing, the remaining plates, and fasten the nuts. | |
| [* black] Parts of the plates should stick out past the tubes as shown. | |
| [* black] Leave them a little loose. | |
| [* black] The pictures show a 7th nut welded on. You'll install that in the next steps so don't worry about it just yet. |