Changes to Step #6
Edit by Dan Benamy —
Edit approved by Dan Benamy
- Before
- After
- Unchanged
Step Lines
| [* black] Parts: | |
| - | [* black] 4 13" x 1" threaded rod |
| + | [* black] 4 13" x 1" threaded rod (TODO link to guide on cutting threaded rod) |
| [* black] 4 2 hole x 4 hole plates | |
| - | [* black] put two plates on either sides of the frame tubes and slide the threaded rods through the top four holes so that the rods stick out a bit on each side |
| - | [* black] TODO better pic |
| + | [* black] Put two plates on either sides of the frame tubes and slide the threaded rods through the top four holes so that the rods stick out evenly on each side. |
Image 1
Old Version
New Version
Image 2
No previous image
Added
Image 3
No previous image
Added