Changes to Step #10
Edit by Dan Benamy —
Edit approved by Dan Benamy
- Before
- After
- Unchanged
Step Lines
| [* black] Parts: | |
| - | [* black] 8 1" |
| - | [* black] 4 |
| + | [* black] 8 1" nuts |
| + | [* black] 4 pivot plates (TODO link to guide on making them) |
| [* black] 2 ounces of grease (I made up 2 oz, Marcin should verify) | |
| - | [* black] Put two Pivot Plates on each sides of the frame tubes, over the 4 threaded rods, and fasten them with nuts. Leave the nuts very loose. |
| - | [* black] Apply grease to both sides of the top (round) part of the pivot plates and inside the bushing (hole). Squeeze some out using the gun and then smear it around. |
| + | [* black] Put two pivot plates on each sides of the frame tubes, over the 4 threaded rods, and fasten them with nuts. Leave the nuts very loose. |
| [* black] TODO pictures of nuts and greasing |