How to assemble the bottom frame of the Ironworker (in progress) Step #10 History

Changes to Step #10

Edit by Dan Benamy — Sun 27 Oct 2013 12:13:25 AM MST

Edit approved by Dan Benamy

	[* black] Parts:
-	[* black] 8 1" ~~Bolts~~
-	[* black] 4 Pivot Plates
+	[* black] 8 1" Nuts
+	[* black] 4 Pivot Plates (TODO link to guide on making them)
	[* black] 2 ounces of grease (I made up 2 oz, Marcin should verify)
-	[* black] Put two Pivot Plates on ~~both~~ sides of the frame tubes and ~~slide the Bolts through~~ with nuts. Leave ~~finger tight~~.
+	[* black] Put two Pivot Plates on each sides of the frame tubes, over the 4 threaded rods, and fasten them with nuts. Leave the nuts very loose.
	[* black] Apply grease to both sides of the top (round) part of the pivot plates and inside the bushing (hole). Squeeze some out using the gun and then smear it around.
-	[* black] TODO ~~picture~~ of greasing
+	[* black] TODO pictures of nuts and greasing