Changes to Step #10
Edit by Dan Benamy —
Edit approved by Dan Benamy
- Before
- After
- Unchanged
Step Lines
| [* black] Parts: | |
| [* black] 8 1" Bolts | |
| [* black] 4 Pivot Plates | |
| - | [* black] |
| + | [* black] 2 ounces of grease (I made up 2 oz, Marcin should verify) |
| [* black] Put two Pivot Plates on both sides of the frame tubes and slide the Bolts through with nuts. Leave finger tight. | |
| - | [* black] put grease inside the bushing and on the flat part where the hole is round (see picture) |
| + | [* black] Apply grease to both sides of the top (round) part of the pivot plates and inside the bushing (hole). Squeeze some out using the gun and then smear it around. |
| + | [* black] TODO picture of greasing |