Changes to Step #10
Edit by jeanbaptiste —
Edit approved by jeanbaptiste
- Before
- After
- Unchanged
Step Lines
| [* black] Parts: | |
| [* black] 8 1" Bolts | |
| [* black] 4 Pivot Plates | |
| [* black] Grease | |
| - | [* black] Put two Pivot Plates on both sides of the |
| + | [* black] Put two Pivot Plates on both sides of the frame tubes and slide the Bolts through with nuts. Leave finger tight. |
| [* black] put grease inside the bushing and on the flat part where the hole is round (see picture) |