Changes to Step #10
Edit by Dan Benamy —
Edit approved by Dan Benamy
- Before
- After
- Unchanged
Step Lines
| [* black] Parts: | |
| - | [* black] 8 1" Bolts |
| - | [* black] 4 Pivot Plates |
| - | [* black] 2 ounces of grease (I made up 2 oz, Marcin should verify) |
| - | [* black] Put two Pivot Plates on both sides of the frame tubes and slide the Bolts through with nuts. Leave finger tight. |
| - | [* black] Apply grease to both sides of the top (round) part of the pivot plates and inside the bushing (hole). Squeeze some out using the gun and then smear it around. |
| - | [* black] TODO picture of greasing |
| + | [* black] 8 1" nuts |
| + | [* black] 4 pivot plates (TODO link to guide on making them) (for the ironworker, it's very important that the plates be perfectly flat against each other. If there are any bumps, grind them down.) |
| + | [* black] Put two pivot plates on each sides of the frame tubes, over the 4 threaded rods, and fasten them with nuts. Leave the nuts very loose. |
Image 3
No previous image
Added