How to assemble all the pieces of the Ironworker (in progress) Step #5 History

Changes to Step #5

Edit by Dan Benamy — Sun 27 Oct 2013 10:59:00 PM MST

Edit approved by Dan Benamy

	[* black] Parts:
	[* black] 1 10" x 1" hardened bolt
	[* black] 3 1" washers
	[* black] 1 1" nut
-	[* black] Put a bolt through ~~the welded~~ nut, the bottom hole of the plates on the frame, 2 washers, the base side of the cylinder, 1 more washer (on ours there was only room for 3 spacer washers), the other plates, and the ~~other welded~~ nut. Make sure the hose connectors on the hydraulic cylinder face away from the rest of the ironworker.
+	[* black] Put a bolt through a drilled out nut, the bottom hole of the plates on the frame, 2 washers, the base side of the cylinder, 1 more washer (on ours there was only room for 3 spacer washers), the other plates, and the last drilled out nut. Make sure the hose connectors on the hydraulic cylinder face away from the rest of the ironworker.
	[* black] Put a nut on the bolt and tighten it and the top one.