Changes to Step #6
Edit by Dozuki System —
Edit approved by Dozuki System
- Before
- After
- Unchanged
Step Lines
| + | [title] Re-Assembly |
|---|---|
| + | [* black] Replace the crossmembers and the cylinder. |
| + | [* black] Insure the pin still fits and hammer it thru. |
| + | [* black] If the pin doesn't fit, you will need to make it fit. |
| + | [* black] Tighten the bolts on only the bottom crossmember. Put the pin thru the crossmembers and the tube. |
| + | [* black] Mark where the bolt holes need to be torched away for the bolts to fit through. Torch it and you're done. |
Image 1
No previous image
Added