Changes to Step #3
Edit by Dozuki System —
Edit approved by Dozuki System
- Before
- After
- Unchanged
Step Lines
+ | [title] Marking hole locations |
---|---|
+ | [* black] Mark the location for the hole for the pin on the bottom horizontal member using spray paint. |
+ | [* black] Put the top member on, and put in at least 3 bolts. Spray mark this location as well, from the other side. |
+ | [* black] Remove the horizontal members from the frame. |
+ | [* black] This is possible to do without removing the cylinder, just prop it up on something to remove the lower member. |
+ | [* black] Place one of the DOM tubing pieces in the center of each of the sprayed marks and spray paint around this to mark where you will torch. |
Image 1
No previous image
Added
Image 2
No previous image
Added