Changes to Step #22

Edit by Robert Kirk —

Edit approved by Robert Kirk

Before
After
Unchanged

Step Lines

+[* 1] place cylinder in position and place shaft through Buesching and cylinder mount and through second Bushing
+[* 1] hold in place to where it will be welded put a small spacer underneath the rod and part of the cylinder to fit exactly within The 4 inch cavity of pivot part one.
+[* 1] The bushing location should be exactly 1.6 inches behind the & whole of the one by four hole plate, Or right behind the hole So that people can be put in the fourth hole of the one by four hole plate