Changes to Step #2

Edit by Robert Kirk —

Edit approved by Robert Kirk

Before
After
Unchanged

Step Lines

-[* 1] Build the Angled Support(pictured in step 3) from a 24" piece of 1/2"x4" plate - then punch 2 holes at 20" spacing using a 1-1/16 bit in an open source Holepuncher Machine.
+[* 1] Build the Angled Support (pictured in step 3) from a 24" piece of 1/2"x4" plate. Punch 2 holes, 2" in from each end and at 20" spacing using a 1-1/16 bit in an open source [[Topic:Ironworker Machine|Ironworker Machine]].
[* 1] These support pieces prevent side-to-side movement of the Quick Attach tubes.