Changes to Step #2
Edit by Robert Kirk —
Edit approved by Robert Kirk
- Before
- After
- Unchanged
Step Lines
| - | [* black] Build the Angled Support from a 24" piece of 1/2"x4" plate - then punch 2 holes at 20" spacing using a 1-1/16 bit in an open source Holepuncher Machine. |
|---|---|
| + | [* black] Build the Angled Support (pictured in step 3) from a 24" piece of 1/2"x4" plate. Punch 2 holes, 2" in from each end and at 20" spacing using a 1-1/16 bit in an open source [[Topic:Ironworker Machine|Ironworker Machine]]. |
| + | [* black] These support pieces prevent side-to-side movement of the Quick Attach tubes. |