/
/

Site Navigation

Your Account

Choose Language

Changes to Step #1

Edit by Brian Peters —

Edit approved by Brian Peters

Before
After
Unchanged

Step Lines

-[* black] All plates are ½” thick steel. Start with two plates cut according to the dimensions in the Fig. The large piece in the center is called “Bucket Side Plate”. Two are required to complete the Bucket. The two smaller triangles at the bottom were designed to be 30/60/90 triangles. The 30/60/90 triangles should control/drive the linear dimensions.
+[* black] Start with two plates cut according to the dimensions in the Fig. The large piece in the center is called a “Bucket Side Plate”. Two are required to complete the Bucket. The two smaller triangles at the bottom were designed to be 30/60/90 triangles. The 30/60/90 triangles should control/drive the linear dimensions.