Changes to Step #3
Edit by Dozuki System —
Edit approved by Dozuki System
- Before
- After
- Unchanged
Step Lines
| + | [title] Drill hole for bolt in coupler |
|---|---|
| + | [* black] Remove the motor and shaft from the mount. |
| + | [* black] Put the coupler back onto the shaft. |
| + | [* black] Drill the 1/4" hole thru the coupler and rod, using the mark you made to make sure the rod is inside the coupler by the proper amount. |
| + | [* black] The hole should be 3/8" away from the edge of the coupler. |
| + | [* black] Drill thru both at the same time. You will need some sort of vise to hold it down while you drill. |
| + | [* black] Double-check that your bolt will fit thru. If not, either re-drill it with a slightly bigger bit, or do another set of holes. |
Image 1
No previous image
Added
Image 2
No previous image
Added