Changes to Step #4
Edit by Dozuki System —
Edit approved by Dozuki System
- Before
- After
- Unchanged
Step Lines
| + | [* black] Once the drawer is properly adjusted, tighten these bolts all the way. |
|---|---|
| + | [* black] Make sure the drawer adjustment nuts are still centered on the roller guides. |
| + | [* black] Tightly bolt the wide cylinder supports to the frame, leaving no gap between them and the drawer members. |
| + | [* black] Tighten the bolts at the top of the wide cylinder supports so they are touching the cylinder on each side. Tighten the lock nut. |
| + | [* black] Go back through the entire frame and make sure every bolt is tight. |
Image 1
No previous image
Added
Image 2
No previous image
Added