Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #6

Edit by Dozuki System

Edit approved by Dozuki System

Before
After
Unchanged

Step Lines

+[title] Mag-Drill the holes for the wide cylinder supports and drawer members
+[* black] Clamp the drawer member centered, 7" from the upper cross member.
+ [* black] The drawer slots should be on this side, not opposite.
+ [* black] Make sure the adjustment nuts are facing where the drawer was, look at the picture.
+[* black] Clamp the wide cylinder support adjacent to it.
+[* green] Make sure you label each component for re-assembly later.
+[* black] Mag-Drill 1" holes at these centers.
+[* black] Don't bolt these yet, you'll do that later.

Image 1

No previous image

Added

Image 2

No previous image

Added