Changes to Step #1
Edit by Dozuki System —
Edit approved by Dozuki System
- Before
- After
- Unchanged
Step Lines
| + | [* black] Loosely bolt the assembled motor to the mount, as shown, using washers on both sides, and a lock washer touching the nut. |
|---|---|
| + | [* black] Put the bearings onto the shaft, ensuring that the eccentric side is facing inwards. |
| + | [* black] Remember to put the eccentrics in between the two bearings. |
| + | [* icon_note] The eccentrics are little collars with lopsided circles inside of them. This makes it so they can lock into the bearings. |
| + | [* black] Ensure that both collars are facing the right direction (so they will lock onto the lip) and that the bearings are also. |
Image 1
No previous image
Added
Image 2
No previous image
Added