Changes to Step #2
Edit by Workshop One —
Edit approved by Workshop One
- Before
- After
- Unchanged
Step Lines
| [* black] ***Cut all framing members for Module 8a*** | |
| - | [* black] Use two people to make the proper cuts according to the dimensions in the images. |
| - | [* black] Simultaneously, use the other two people in your group to assemble the framing pieces using two 3-1/8" construction screws per connection, screwing perpendicular to the bottom plate and top plate. |
| + | [* black] 2: 2"x4"x3'4-7/8" (horizontal top and bottom members) |
| + | [* black] 4: 2"x4"x5'5/8" (vertical members) |
| + | [* black] ***Assemble*** |
| + | [* black] Verticals go inside of horizontals, one on each edge, one at a distance of 2.5" from the left-most vertical, and one 1'2-1/2" from the right-most vertical. This layout should result in a 1'5-7/8" gap between the inner-most verticals. |
| + | [* black] Use 3-1/8" screws to attach all framing. Screw through horizontals into end grain of verticals (2 screws per joint) |