Changes to Step #5
Edit by Workshop One —
Edit approved by Workshop One
- Before
- After
- Unchanged
Step Lines
| + | [* black] ***Interior sheathing for module 5a*** |
|---|---|
| + | [* black] Cut the 17 degree angle on the piece by marking the two vertical distances and snapping a guide chalk line to connect the two. Use a 7-1/4"circular saw to make the cut. |
| + | [* black] Keep the rest for future use for Mod. 5b and the small 1" wide pieces in this module |
| + | [* black] Align the sheathing with a 1/4" overhang on the left flush with the bottom plate. The offset will create 1/4" gap on the right side for the previous module to attach to. The top overhang should be 1.5" to cover the top plate that will unify the modules during installation. The bottom overhang will cover the width of the bond beam. |
| + | [* black] Fasten the 1/2" plywood to the framing using 1-5/8" coated deck screws around the perimeter and interior studs @ approximately 16" spacing. |
| + | [* black] ***remember that the "scraps" from this 1/2"x4'x8' sheet will be used for the interior sheathing for Mod. 5b*** |
Image 1
No previous image
Added
Image 2
No previous image
Added