Changes to Step #5
Edit by Workshop One —
Edit approved by Workshop One
- Before
- After
- Unchanged
Step Lines
| + | [* 1] ***Interior sheathing for module 3a*** |
|---|---|
| + | [* 1] Cut the 17 degree angle on the piece by marking the two vertical distances and snapping a guide chalk line to connect the two. Use a 7-1/4"circular saw to make the cut. |
| + | [* 1] Keep the excess plywood for [add plywood use here] |
| + | [* 1] Place the plywood on edge along the bottom and left (taller vertical) edge to create a 3/4" gap on the right side for the previous module to attach to. The top overhang should be 1.5" to cover the top plate that will unify the modules during installation. |
Image 1
No previous image
Added
Image 2
No previous image
Added