Changes to Step #5
Edit by Workshop One —
Edit approved by Workshop One
- Before
- After
- Unchanged
Step Lines
| [* black] Interior sheathing for module 1a | |
| [* black] Cut the 1/2" OSB at 3' parallel to the short side of the piece to keep the rest for future use for Mod. 1b and the small 1" wide pieces in this module | |
| + | [* black] Keep the rest for future use for Mod. 1b and the small 1" wide pieces in this module |
| + | [* black] Fasten the 1/2" plywood to the framing using 1-5/8" coated deck screws around the perimeter and interior studs @ approximately 16" spacing. |
| + | [* black] repeat above procedure for the smaller piece of module |
| + | [* black] ***remember that the "scraps" from this 1/2"x4'x8' sheet will be used for the exterior sheathing for Mod. 1b*** |
Image 3
No previous image
Added