Changes to Step #3
Edit by Workshop One —
Edit approved by Workshop One
- Before
- After
- Unchanged
Step Lines
| [* black] ***Exterior Sheathing for Module 1a*** | |
| - | [* black] Cut the 17 degree angle on the piece by marking the two vertical distances and snapping a guide chalk line to connect the two. |
| + | [* black] Cut the 17 degree angle on the piece by marking the two vertical distances and snapping a guide chalk line to connect the two. Use a 7-1/4"circular saw to make the cut. |
| [* black] Keep the rest for future use for Mod. 1b and the small 1" wide pieces in this module | |
| [* black] Fasten the 3/4" OSB to the framing using 1-5/8" coated deck screws around the perimeter and interior studs @ approximately 16" spacing. | |
| [* black] repeat above procedure for the smaller piece of module | |
| [* black] ***remember that the "scraps" from this 3/4"x4'x8' sheet will be used for the exterior sheathing for Mod. 1b*** |