Changes to Step #5
Edit by Chris Reinhart —
Edit approved by Chris Reinhart
- Before
- After
- Unchanged
Step Lines
| + | [* black] Take your two boards with the layout marks on them and set them across from each other so that the marks line up. |
|---|---|
| + | [* black] Lay your two pieces with the layout marks on them facing each other and lay your six 6' - 9" pieces in between, roughly in the position of the marks. |
| + | [* black] ***Pre-drill two holes from the outside at the ends of the board to avoid splitting*** as shown on the second photo of this step. (The pre-drilling is only necessary at the ends of the board, not in the middle.) Screw (or nail, if you choose) the pieces into position. |
| + | [* black] ADD IMAGE SHOWING THE DRILLING AT THE ENDS. THE SECOND IMAGE SHOWS SCREWING IN THE MIDDLE, SO THE LANGUAGE AND THE PICTURE DON"T LINE UP RIGHT NOW. |
Image 1
No previous image
Added
Image 2
No previous image
Added