Changes to Step #6
Edit by Chris Reinhart —
Edit approved by Chris Reinhart
- Before
- After
- Unchanged
Step Lines
| + | [* black] Add a second long board to the other side of your assembly. It should come flush with the other butt of the board running across the bottom. |
|---|---|
| + | [* black] Build a header that will slide into the top of the frame as shown in the image. This is made with two 3' - 3" boards sandwiched around scraps of 1/2" sheet material. Screw this all together with pairs of 3" screws at both ends and a pair in the middle. |
Image 1
No previous image
Added