Changes to Step #9
Edit by Chris Reinhart —
Edit approved by Chris Reinhart
- Before
- After
- Unchanged
Step Lines
| + | [* black] Add the plywood top to the frame. |
|---|---|
| + | [* black] The long edge will be flush with the front of the frame, and the short sides will be flush the long plywood sides. |
| + | [* black] Screw this into place with 1 1/2" screws - put one on each end and two evenly spaced in between. Make sure these screws are going into the 2x4 framing, not the other plywood. |
| + | [* black] Once you have the plywood screwed in, use 6d or similar nails to tack the edges of the plywood together. Hold them flush as you do this. Pre-drilling holes is helpful for those with less experience. |
Image 1
No previous image
Added