Changes to Step #6
Edit by Andrew Graham —
Edit approved by Andrew Graham
- Before
- After
- Unchanged
Step Lines
| + | [* black] Lightly clamp P33 onto P31 maintaining the 90 degree angle in the joint as in the diagram. Since there is a washer in between on the shaft, 2 clamps may be required to keep everything flat. |
|---|---|
| + | [* black] Take one of the P33 parts and clamp to the middle p26 shaped piece. Place P26 Strut against the lid, ensure it is parallel with P33, and weld in place. |
Image 1
No previous image
Added
Image 2
No previous image
Added