Changes to Step #3

Edit by Anthony Douglas

Edit declined by Andrew Graham

Before
After
Unchanged

Step Lines

-[* black] Weld 4 teeth at the proper spacing (4" on center ? and 2" on center from edge ? ) to part 15 (tooth bar bolt bar), with X inches overlap between P18 and P15
+[* black] Weld 4 teeth at the proper spacing (6" on center and 3" on center from the edge) to part 15 (tooth bar bolt bar), with 4 inches overlap between 18 and 15, protruding from the side of the plate that is farthest from the holes. Make sure the tooth bar bolt bar is oriented correctly relative to where the teeth are placed.
+[* black] The teeth go on the side farthest from the bolt holes.
[* black] Repeat for the 2 other P15 parts
+[* black] bug note: the tooth bars are symmetrical, not as shown. The tooth on either end of the bar are the same 3" from each side, not scooched over to one end of the bar.