Changes to Step #4

Edit by Andrew Graham

Edit approved by Marcin

Before
After
Unchanged

Step Lines

[* black] Tack P7 into place with a gap of 1" on both ends from the bottom sheet and back plate. This distance is important for the two P6 parts to be welded in next. there should also be a 1" depth in from the top edge of the sidewall.
[* black] Put in both P6 parts and tack.
[* black] Tack in the second P7.
[* black] Fit lid P2, and if it fits, remove it and finish the welds on the seal.
+[* black] Grind out the extra material around the welds on seams P6-P7 on the seal so the lid will sit flush on top.

Image 2

Old Version

New Version

Image 3

Old Version

New Version