Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #2

Edit by Andrew Graham

Edit approved by Marcin

Before
After
Unchanged

Step Lines

-[* black] Tack weld backplate (P1) using a set square at a 90 degree angle on top of P3, don't finish the weld. tack sidewall P4 into place at 90 degrees.
+[* black] Tack sidewall P4 into place at 90 degrees.
[* black] Hold sidewall (P5) into place, and then stick Shaft 21 through the bearings to ensure proper alignment of side walls. Tack sidewall (P4). Now tighten the bolts, ensuring the shaft is aligned correctly.
[* black] Finish welding the seams for the back plate, bottom sheet and sidewalls (P1, P3, P4, P5). Weld in the 1" nuts on the inside side of the sidewalls